Sunday, August 24, 2014

Tips on Jammed Sewing Machines or Correcting Improper Stitching


Because I have been asked this many times over the years, I figured a write up is in order.  Has your sewing machine jammed or is stitching a mess suddenly?

Stop!  Don’t keep sewing messy seams.  They will just fall apart most likely.  

Stop and take the time to get it right.  Besides you can do a lot more damage trying to force it to sew when something isn’t right.  You can damage the item you are sewing, or even worse your machine.

Don’t panic and call the repair people yet.  Odds are good you can fix it.  Don’t give up on sewing either.  Consider it a learning experience.  Every seamstress will wrestle with her machine once in a while.  Talk nice to it, it helps keep your mood civil while you tinker.  ;-) The more you do it, the better you learn your machine and eventually you will be an expert on that machine.

Resist the urge to go messing with your tensions if it was sewing properly the last time you used it.   Smack your own hands away if you have to!!  Odds are you will just mess that up.

Look for obvious improper threading.  Check both the upper thread and the bobbin.

Rethread the machine.  Upper and bobbin.  Don’t partially do it...do it fully and completely.  Sometimes the silliest things will be solved by a re-thread and you will never really “see” what the issue was.  Be sure when you un-thread, you pull only in the direction the thread normally goes.  To do otherwise will mess your tensions up.  There is an exception when you get REALLY desperate.  More on that later.

Clean the machine well with a brush.  Avoid compressed air unless absolutely necessary.  A brush is always better so you don’t blow fuzzies back into the depths of the machine.  Not to mention canned compressed air kicks off chemical sometimes instead of just air.  Not healthy for you or your machine.

When you clean it, remove the throat plate too. (The area your needle goes down into)  You will be shocked at what accumulates there.  Never underestimated the ability for fuzzies to ruin your tension and stitching.  Clean it meticulously. 

Re-thread the machine properly again for good measure.  (seriously, I have re-thread what felt like a million times before..LOL)

Change your needle.  Many people sew on needles too old.  I am guilty of it too.  Sometimes a needle will have lost it’s point or be bent to where your eye doesn't see it well visually.  A bent needle will kill your stitching line and be messy.  It can also damage your machine.  For that matter, avoid sewing over pins.  Many a lady has ruined her machine’s timing from doing that.  At very least, only sew over them when you REALLY have to in a tight spot on something hard to hold.  If you chose to sew over pins, don’t get mad at anyone but yourself if you kill your machine.  If your needle hits a pin, assume at very lest it is probably bent with a dull point now.

Oil the machine, but only in the proper places and just a little as necessary.  (see your manual)  Make sure you sew on a scrap for a while after oiling.  If you get too heavy handed with the oil, it can come up into your stitching and kill whatever you are sewing.

Re-thread it again.  (You might be laughing...but I am serious :-))  For that matter, get a new bobbin and wind a new one.  I have also had bad bobbin winding cause poor stitching.  Make sure your bobbin is in it’s case properly and spinning in the proper direction (if you have a bobbin case for your machine).  If you have a drop in bobbin, you still need to be sure you are putting in down there properly and in the right direction.

Then and only then go playing with your tensions if it still isn’t right.  One exception to this rule.  If you have small children always make a mental note of your normal tensions so you can see at a glance if they decided to play with the knobs and buttons.  (guess what happened to me today!!!)

At your own risk on this one....but you can try flossing your machine.  Not with dental floss, but your thread.  Unthread the needle.  Take ahold of the bottom and then grab the thread from behind the machine coming off of the spool.  Gently and firmly move it back and forth just a little bit.  You might find you dislodge a big ol’ piece of lint in your tension discs if your machine has those.  Again, GENTLE!!!  It is a risky thing.  I was most prone to do this with my older serger where things would lodge in the tension discs regularly.  More modern machines with computerized tensions, it is a really bad idea.  So this one is very much at your own risk.

Finally re-thread your machine.  ;-)


Hopefully one of these solves your issue.  One final tip that has nothing to do with your threading or stitching...just a sewing PSA.  Please, I beg of you, stomp not on thy foot pedal.  Your seams are not a race!  Sew at a reasonable speed limit.  As my husband once counseled me, enjoy the process of sewing not just the result.

Do you have any tips to share?  Feel free to share in the comments!  I know some of seamstresses can be a bit opinionated on the matter.  I would love to hear others thoughts on this one.







Add on tips from others:


Baby Lock recommends the "unwaxed" dental floss (never ever waxed floss) running it down like your thread would go.  I know you didn't recommend floss, but I have seen it recommended and I am sure it was Baby Lock since I use it for that one.  Bernina folks say to use a dollar bill.
Also, if you get a new needle or esp. two or more out and put in the machine and it is still bad, try one from another new package.  You can get whole packs of bad needles and I know that for a fact, it happened over at a local shop, they got a whole batch of them and had to have them replaced...I bought some of them....and still run into some of them.....

You can also get a burr (sp.) on the throat plate from a broken needle that will cause havoc.  They recommend an emory cloth for that.
...........................................................................................................

Wednesday, August 20, 2014

Examine Yourself: Are you doing what you condemn?

Fair warning....I don’t feel very good and this might be a bit more blunt than I usually am.  I am not saying it to be mean however, but hopefully to inspire some self examination.

You get upset and frazzled about men looking at your body, yet at the same time you have shirtless pictures of muscular men on your FB wall?  Witty sayings on the pics don't make them any cleaner.  You don't think those are as stumblingblock to other women?  I am here to tell you they absolutely are.  

Even more, do you not see the overall disconnect in your logic?  You are choosing to do the same thing you condemn and dislike.   You call men names and moan of the the way they are.  You feel they see women inappropriately.  You don't want to be a piece of meat to be devoured.  They look at you, call to you, smile at you and you become angry.  You feel used and like an object.  However, how is that picture of the sweaty dude you giggled at and maybe thought of him as "eye candy" any different?  Are you not treating him the same way you DON'T want to be treated?!  It is a fool who mocks another's sin when they are doing the same thing!
 
It is very much like those who knock a man for looking at porn, then fail to abstain from romance novels that have the same content.  Written format can create just as much sin as visual format.  If you are going to chastise and mock others for sin, make sure you aren't doing the same thing just in a sugar coated form.  Please don’t sugar coat abomination.  Women like to make things sound sweet, thus the term "eye candy"...but come on...call it for what it is.

Here is the next line of thought.  I know there is a degree of subjectivity of the word modesty.  I get that.   The Bible does require modesty in no uncertain terms.  Humans and believers will argue what constitutes modesty until we are blue in the face.  Some of us just see things differently there.  

Ultimately it is between each person and God.  Here is a thought though, make sure that your own opinion of your modesty standards meet the Biblical one.  You don't want to compare it to the cultural standard.  Compare only to the Biblical one.  That is the best advice I know of.  Don’t worry over anyone else’s standard, just make sure you meet God’s.  

Getting too much unwanted attention can be a sign that you might be showing too much for free.  Don’t show off the goods, then get upset if someone window shopped.  Now I realize it is possible to be extremely modest and still get a little unwanted attention.  I am not saying it means you are for certain dressing inappropriately.  It is simply something that needs checked and examined if you are having this happen on a regular basis.
 
Finally, make sure you are approachable for other sisters in Christ to talk to you about these things.  Do you have a tendency to get highly upset anytime someone suggests you might want to watch your walk and witness.  When is the last time you listened to and weighed a correction examining yourself to see if the person might a point?  Do you start making posts about “how dare anyone judge me”...etc...  Resistance to even the hint of correction is a FLAMING sign that you aren’t walking the narrow path you should be!!!  

Is it politically correct to admonish someone else.  No.  

Should we care about what is popular in such matters?  Nope.  

It is however Biblical to correct to help one another along the narrow path.  That is a GOOD thing.  Not something we just bristle at and scorn.  

Yes, at one time or another I have been guilty of the same stuff.  It has opened my eyes to some of this stuff though.   Perfection I will likely never attain in the time I have left on this ol' earth.  Shucks most humans couldn't agree on what even defines perfection.  

God is perfect!!! Study Him and try to be like Him!!!!  Walk the narrow path He laid out for us in His Word.

Examine yourselves, whether ye be in the faith; prove your own selves. Know ye not your own selves, how that Jesus Christ is in you, except ye be reprobates?  ~2 Corinthians 13:5

Thou hypocrite, first cast out the beam out of thine own eye; and then shalt thou see clearly to cast out the mote out of thy brother's eye. ~ Matthew 7:5